Spenco TOTAL SUPPORT™ INSOLES (39-313)

PolySorb® Total Support Insoles create an advanced arch support and deep heel cupping for a Total Support System.

How it works:

See a video on this Spenco Product – click here

The unique and patent pending 3-POD Cushioning Insole System absorbs shock and helps prevent over-pronation, the leading cause of many common injuries such as plantar fasciitis. For additional arch support and protection, PolySorb Total Support Insoles are heat moldable to provide a custom fit (see directions below). The Forefoot Crash Pad Provides extra cushioning under the ball-of-foot for a smooth transition to toe-off. The Reverse Mortons Extension Creates a toe-off pad for greater propulsion. The Heat Moldable Layer Custom fit of the Insole provides maximum support and performance, helping reduce friction that causes blisters. Also, a Low Friction Top Cloth with Anti-microbial Odor Control helps prevent blisters while controlling odor.

DIRECTIONS FOR INSOLE USE:

Remove the original insole from the shoe (some brands of shoes glue the insole to the shoe, but careful removal will not damage the shoe). Use the original insole as a guide to trace and trim the Spenco PolySorb® Total Support Insoles. Insert the Spenco Insoles into the shoe.

CUSTOM INSOLE MOLDING DIRECTIONS:

DO NOT MICROWAVE. Make sure the insoles fit properly in your shoes before heating. Wear athletic socks during custom molding. Preheat oven to 200F degrees Fahrenheit. Place the PolySorb® Total Support Insoles directly on the oven rack, fabric side up, for three minutes. Carefully remove both the insoles and quickly place them in your shoes. Place your feet in your shoes and lace them securely. Stand on the insoles for one minute before walking. After 10 minutes, the molding will be complete.

• Because of the advanced arch support, some break in time may be required. During the first 48 hours, you may experience some discomfort until your feet are able to adjust to this new level of support.